Impact Precision Action fitting into KRG Whiskey 3 Gen 6

[Roadking2015]

Good evening brains trust, I was hoping to find someone who has fitted an Impact Precision Action into a KRG Whiskey 3 gen 6 chassis, I know there is some machining requirements regarding the hanging trigger set up with the Impact Action to get it to fit but was wanting a bit more detail with the process and what's involved . Any advise would be gratefully appreciated.
Cheers

 

[greentick]

I have a KRG Bravo/Impact combo. I emailed back/forth with KRG and they sent me very helpful pics. There was a thread here regarding Bravo/Impact combos that was very helpful too. When I spoke with Impact about my plans they included low profile screws for the trigger hanger. A few careful minutes with a dremel did the trick. I spent more time taping off everything than dremeling.

 

[Roadking2015]

I have a KRG Bravo/Impact combo. I emailed back/forth with KRG and they sent me very helpful pics. There was a thread here regarding Bravo/Impact combos that was very helpful too. When I spoke with Impact about my plans they included low profile screws for the trigger hanger. A few careful minutes with a dremel did the trick. I spent more time taping off everything than dremeling.

Cheers for that, I might have to email KRG and see if they can send me the same pics, really appreciate your input mate, I have mine with my gunsmith but he has not worked on KRG chassis all that much so thought I would try and find something on the topic for him.
Thanks again