Kestrel, 100 is not zero on range/target card

[FieldGaugeFailure]

So, I've never looked at my Kestrel values below around 300 yards before. I took a peek at them today while building a profile for a new optic configuration, and noticed that 100 yards isn't 0, my Kestrel is telling me to hold .31 down in elevation. Gun is set to 100 yard zero, units are set to imperial. Is this normal?

 

[Lowlight]

That is because of the drifts they add in, in reality our drifts are 1.25% of elevation and the Kestrel / AB shows you 3% so you can see it... turn Wind 1 off and it will be zero

If you don't use Wind 1, it zeros back out

Using Wind 1, vs Not using Wind1, I dont' use wind 1

 

[FieldGaugeFailure]

Good call, I didn't even think about the wind, as I'm inside right now and didn't factor that when pulling up the data.