Suppressors KGM R6.5 & R30T cover dimensions needed

[spooledup]

Is there someone here who can help me out with two dimensions? I am ordering some suppressor covers from Hunter-Steve and need the following measurements.

The length from behind the APEC ports to the base of the can. So just the flat section for both the R30T and the R6.5.

Thanks in advance!

 

[southernpew]

If no one answers you by the time I get off work, I have some of these in jail at my LGS. I can grab those measurements after work

 

[ballistictip1088]

Here is the 30cal on the bench and 6.5 on the gun. I run a 6” cover on my 6.5

I have the tape about a 1/2” behind the front of the suppressor so the measurements are from behind the ports. Not sure if that’s clearly seen in the pics

 

[spooledup]

Thanks for the information @ballistictip1088 and the offer @southernpew! So it looks like 6” will work on both. The R30T and R30 should be relatively similar with the exception of the mounting device.