Hey guys, I've got a Sentinel stock that I want to send to GAP for a build. It's got the integrated mounting block for a Surgeon 591 but wanted to know if the new Templar V2 would drop right in also
Thanks
Thanks
KMW Sentinel mounting block
- Thread starter RollinCoal11
- Start date
I would imagine that it would, but, I'm not sure about the bolt release. They seem to be the problem most of the time with metal chassis'. Nothing a lil milling won't fix though.
I doubt it. There is a reason why Terry makes an IMB specfically for the Templar.
Sell me the stock instead! PM me payment details.
Sell me the stock instead! PM me payment details.
Ejection port cut will need to be pushed a bit further to the rear.
Double check the bolt handle clearance.
Other than that, you should be good to go.
My next batch of IMB-S-RH will have revised dimensions to accommodate everything that it currently does plus the Defiance Deviant series.
Double check the bolt handle clearance.
Other than that, you should be good to go.
My next batch of IMB-S-RH will have revised dimensions to accommodate everything that it currently does plus the Defiance Deviant series.
Terry- I'm planning to order another stock before long, do you make a mounting block for a Badger short action or should I just get a standard type inlet?
I went with an inlet and KMW bottom metal for my M2013 build. It turned out great. Clean lines and the bedding job is flawless.
I spoke with Terry about this a month or two ago. The mounting block is not available for the Badger action.
I'll just stick with the Surgeon action (whenever I can get one). That stock is just too perfect to do any modding on.
It will work just fine for a V2 Templar. a couple easy mill cuts and it will drop in nicely
Similar threads
