Load Recommendation for Tikka CTR 6.5 Creedmoor 24" Stainless

dieselcruiserhead

Private
Minuteman
Sep 19, 2019
19
2
In the next month I'll be hanging with some friends who are reloaders and I'm just getting into it and am looking for a good place to stsrt. I'm shooting this Tikka 6.5CM in the 24" stainless which I believe is about a .8" barrell at the end. Has a custom brake and chassis, is otherwise stock. It has been inspected by my smith and he says it should shoot great.

If it helps, for factory ammo, Winchester Match (my former go to) 140 sierra kings, has not been good in this gun. But formerly shot awesome in my previous gun which was a Savage with a Proof barrel, dime size holes at 100 yards no problem truly a tac driver, with the same scope now on this Tikka. I hear Hornady ELD Match 140 is great in this gun.

I hear a slow burning powder like 4350 and slow burning primers are good. I have 140 and 150 grain bullets and a few hundred well prepped once fired cases. I like the sierra bullets but am happy to try anything.

All ears on your recommendations.
thanks
 

Attachments

  • 0626201846d_HDR.jpg
    0626201846d_HDR.jpg
    176.4 KB · Views: 65
  • 0626201847_HDR.jpg
    0626201847_HDR.jpg
    272.6 KB · Views: 54
  • 0626201846_HDR.jpg
    0626201846_HDR.jpg
    158.3 KB · Views: 64
  • 0520201937_HDR.jpg
    0520201937_HDR.jpg
    687 KB · Views: 58
Last edited:
I’m a relative noob reloaded compared to many, so take that into consideration. Also, note that every rifle is different so start at the low end of published data and work your way up. That being said,I have the same rifle. It seems to really like
140 ELDM bullets with 41.5 grains of H4350. I’m using full length sized ( expander ball removed, using a mandrel separately) and annealed Hornady cases. 0.002” bump and 0.002” neck tension. Federal 210M primers. I’m getting 2715 fps on average with single digit/ low teens SD. Keep in mind Tikka barrels tend to run a bit slower so don’t expect to get the same velocities as someone else with similar loads out of different rifles / barrels. Good luck.
 
  • Like
Reactions: dieselcruiserhead
I have a tikka t3x 24" stainless in a KRG bravo stock. 40.8gr H4350 and 140 eldm. @ .4" at 100. 2710fps, fed 210m. It also shoots the berger 140 just as well but they are 10 buks more. Mine has a little bastard brake and it shoots slightly better w out the brake @.3". It took alot of work to tune the brake down to the .4" group.
 

Attachments

  • 20200513_193906.jpg
    20200513_193906.jpg
    663.8 KB · Views: 76