What is your procedure for brass prep from start to finish ? Thanks in advance
- Thread starter patrick021
- Start date
Read the stickies on the reloading forum page. There are several different ones that have the information you're asking for.
1) Dirty brass gets decapped (rifle only)
2) Wet tumble in steel
3) Dry in dryer
4) Anneal w/ old school blow torch
5) Toss in the box until ready to use
6) Take out of box, F/L size
7) Trim in Giraud
8) Prime
9) Charge
10) Seat to spec
2) Wet tumble in steel
3) Dry in dryer
4) Anneal w/ old school blow torch
5) Toss in the box until ready to use
6) Take out of box, F/L size
7) Trim in Giraud
8) Prime
9) Charge
10) Seat to spec
Thanks
