Does anyone know if a 9x36 Logan lathe would be any good for barrel/action work? It is a older one that looks to be restored. Thanks..
Gunsmithing Logan lathe
- Thread starter myownman
- Start date
Re: Logan lathe
http://www.lathe.com/models.htm
ETA: I didn't see a 36" model listed on that page, but all of the other 9" Logans have a 25/32 Spindle bore which would be too small for most barrel work through the headstock.
http://www.lathe.com/models.htm
ETA: I didn't see a 36" model listed on that page, but all of the other 9" Logans have a 25/32 Spindle bore which would be too small for most barrel work through the headstock.
Re: Logan lathe
There is a Logan users group on Yahoo. Scott Logan is a frequient contributor and can answer any question you may have. I have a Logan 400 bench lathe and love it for small work. The issue with the older lathes is the bore thru headstock spindle. It's going to limited for gunsmith work unless you can get a barrel thru it.
http://finance.groups.yahoo.com/group/lathe-list/
There is a Logan users group on Yahoo. Scott Logan is a frequient contributor and can answer any question you may have. I have a Logan 400 bench lathe and love it for small work. The issue with the older lathes is the bore thru headstock spindle. It's going to limited for gunsmith work unless you can get a barrel thru it.
http://finance.groups.yahoo.com/group/lathe-list/
Re: Logan lathe
I just looked at that model list JRM posted. The 400 has the same spindle bore. I cant hardly get a muzzle brake in mine.
You can always buy a Grizzly gunsmith lathe and keep it at my house.
I just looked at that model list JRM posted. The 400 has the same spindle bore. I cant hardly get a muzzle brake in mine.
You can always buy a Grizzly gunsmith lathe and keep it at my house.
Re: Logan lathe
Thanks guys !! That's what I needed to know...
Thanks guys !! That's what I needed to know...
Re: Logan lathe
I have a Logan 11 X 36 (Heavy I believe) and its been a very good and accurate lathe. It has a thru hole that I would consider a minimum for gunsmith work.
I converted the 3 phase power to a VFD drive and a drum switch.
I have a Logan 11 X 36 (Heavy I believe) and its been a very good and accurate lathe. It has a thru hole that I would consider a minimum for gunsmith work.
I converted the 3 phase power to a VFD drive and a drum switch.
