Mark 7 Apex 10 vs Revolution

[Graye2]

Hi all…it’s been a while since I posted anything, I guess a function of work keeping me busy and not shooting as much…

I’m trying to get back into the swing of things and have been considering a Mark 7 to help speed things up a bit. I love my 750 but have been considering an Apex 10 or Revolution. I’ve searched and just haven’t found much on the Revolution whereas there are plenty of videos and posts on the Apex. I know both are crazy expensive fully equipped but I don’t want to buy the Apex and regret not giving the Revolution more consideration.

Any if you have any experiences that you could share between the 2?

Happy 4th!!

 

[R_A_W]

I use a manual Apex 10 & it's great. If you need the stations, I don't think there's a better progressive for precision or just processing brass. Can't comment on the Revolution.

Variance on headspacing is very impressive - my headspacing ES works out to +/- 0.00075 (3/4 of 1 thou) across 200-300 pieces. I can't beat that with my Rockchucker. I've only once seen headspacing ES above +/-0.001", which was due to inconsistent application of lanolin. Seating bullets & primers are very consistent as well.

Issues...
1) Everyone complains about priming, but they're doing it wrong. I was doing it wrong as well & had the same issues. After about 2k loaded rounds, I placed a Cortina mandrel die over the priming station to hold the case in place during primer seating That change immediately & completely resolved all priming issues - I haven't had a single priming issue since.
2) The pawl does tend to come untimed & I don't think there's a solution to this... but it takes 5 seconds to time every few hundred cycles, or you can just run the press untimed & will continue function fine.

It's a progressive with its own nuances, you'll fight it for a bit & then figure it all out. What do you intend to load with it?

e: I have a better example than this, can't find the .xls right now...