Anyone worked up any loads using this brass? Any problems encountered? Reduced internal case volume? All input would be greatly appreciated.
Thanks
Paul
Thanks
Paul
Mk 248 Brass?
- Thread starter pmuniz10920
- Start date
MK 248 is ran at fairly high pressure. I would assume a limited number of reloads . Neck sizing may help, bump shoulders back every 2nd or 3rd reload.
Mk 248 Mod 1 is over typical pressures, and most likely will be loose on the primer pockets. It's high enough over pressure, that Black Hills, who designed the round to sling a 220 SMK at 2850, wont produce it commercially. So, you might make sure that the brass isnt toasted already.
I believe it is mk284 Mod 0 brass date is 2007/2008 on most. Primer pockets seem fine, a little snug. Not loose is any way.
Anyone know what the regular internal case volume is for a 300WM?
While I was waiting for my 190's to come in I was playing with 220's. getting stuck bolt with 70.0g H1000. I'm gonna back down a bit. But like I say, I was just messing around and it seemed odd.
Anyone know what the regular internal case volume is for a 300WM?
While I was waiting for my 190's to come in I was playing with 220's. getting stuck bolt with 70.0g H1000. I'm gonna back down a bit. But like I say, I was just messing around and it seemed odd.
