i just purchased an apa bottom metal, I'm unsure if i want to tackle its installation with a dremel as it seems like it will be terrible. anyone on here know someone or do it themselves in the va beach area?? or hell anywhere at all?
Gunsmithing need help inletting my bottom metal
- Thread starter Duffy1298
- Start date
Re: need help inletting my bottom metal
Its not that bad to do it your self if your the DIY type. Id bet that APA would be able to inlet your stock for you.
Its not that bad to do it your self if your the DIY type. Id bet that APA would be able to inlet your stock for you.
Re: need help inletting my bottom metal
its a rem700 pss take off. I hate to pay to have the thing inletted but i cannot stand the standard rem mag, so ill bite the bullet and have it done till my mcmillan is made.
its a rem700 pss take off. I hate to pay to have the thing inletted but i cannot stand the standard rem mag, so ill bite the bullet and have it done till my mcmillan is made.
Re: need help inletting my bottom metal
You are gonna have to cut into the aluminum block in that stock to get the APA to fit.
This is best done on a milling machine, not by hand...
You are gonna have to cut into the aluminum block in that stock to get the APA to fit.
This is best done on a milling machine, not by hand...
Re: need help inletting my bottom metal
yea i think im going to have to figure out someone that can do it forr me
yea i think im going to have to figure out someone that can do it forr me
