I need to know the dimensions of the rear pin on a winchester trigger both lingth and diamater.
Also looking for one if someone has a extra.
Please PM the info
Also looking for one if someone has a extra.
Please PM the info
Gunsmithing NEED Winchester info
- Thread starter esromvre
- Start date
Re: NEED Winchester info
Not sure what you mean by rear pin...there is only one trigger pin.
I just measured the one from my FN SPR:
It is stepped.
Head diameter: .250"
First step diameter: .136"
Second step: .119"
Overall length: .775"
Length from underside of head to step: .188"
Measurements taken with a known-good dial caliper. That last measurement is not readily taken with a caliper and is pretty much a guess, but it is not a precision feature so I wouldn't sweat it.
Not sure what you mean by rear pin...there is only one trigger pin.
I just measured the one from my FN SPR:
It is stepped.
Head diameter: .250"
First step diameter: .136"
Second step: .119"
Overall length: .775"
Length from underside of head to step: .188"
Measurements taken with a known-good dial caliper. That last measurement is not readily taken with a caliper and is pretty much a guess, but it is not a precision feature so I wouldn't sweat it.
Re: NEED Winchester info
I have a post 64 pushfeed short action the trigger has 2 pins just like a rem. the back one holds the triger and the bolt stop and bolt stop spring.
But those measurments sound like what i need
I have a post 64 pushfeed short action the trigger has 2 pins just like a rem. the back one holds the triger and the bolt stop and bolt stop spring.
But those measurments sound like what i need
