Selling a used magnetospeed mount made by mpa. Comes with both the long rail for suppressor use, the short rail for no suppressor, two spacers, and the rat arca clamp and an unused mpa rotating barricade stop.
Attaches to the arca spigot mount on an mpa or similar setup. If you have an mpa that's somewhat recent, the spigot is both arca and picatinny. You could also take off the mpa rat clamp and put an adm picatinny or similar 1.1" screw spacing clamp on the rail and use it on picatinny as long as it has a recess cut out of the clamp similar to setups that work on an atlas bipod
Here's a picture of one way you can set it up. I've run it clamped on to the actual arca cut in the chassis but the chrono is a little further from the barrel. Still picks up shots but it's not placed in position according to the magnetodpeed manual.
The bipod in the picture is using the same clamp as well
Only because yesterday when I contacted masterpiece arms they were out of stock and I messaged you at 5 AM this morning and your message went to my junk folder so I waited until 9:30 AM and received an email from masterpiece arms saying that they had some in stock so I bought from them.