Origami stock set up... advise for my AIAX?

[Trek]

So many adjustments- permutations/combinations are endless... how did you determine your set up? My length of pull was too long.. came back from the range today with a 1cm slash on my check... I was at the end of my check riser and the recoil from the308 opened me up.... stock is now broken in! ?. I’m 6’ 35” sleeve - I installed the larger LOP spacer but will go back tomorrow... how did you determine 1) LOP; 2) Butt pad angle, and 3) Butt pad height for prone... thoughts, photos welcome. Thanks for your help!

 

[Eric32]

Judging by the end of cheek riser issue your scope is too far forward causing you to crane your neck out.

Place your cheek on the stock in the middle of the pad. And BRING the scope to you. Also bring the buttstock into your collar bone. Try getting it in the center of your body.

LOP take your trigger finger in a proper 90° bend and measure from that to your inside elbow also at a 90° bend. And then subtract about 2 inches.

 

[Trek]

Eric, good advice. I’m switching back to the original spacer… and will landmark on the center of the cheek riser… I may even asked an RO to take a photo of my set up as it’s difficult to put in position without an extra body, thanks for your help!