I'm seeing PRI Gen III Free Float Tube Handguard for DPMS 308's on Midway. Made out of carbon fiber. I'm interested in the rifle legth version on a 18" build I'm considering. Anyone using one and what do you think about it. Thank you.
- Thread starter Surffshr
- Start date
Re: PRI Free Float Tube for DPMS
I played around with them at the SHOT Show, I loved them. They are not much lighter than other units, but I just like they way they look and feel.
Check out their new triangular version, its my favorite!
Mark
I played around with them at the SHOT Show, I loved them. They are not much lighter than other units, but I just like they way they look and feel.
Check out their new triangular version, its my favorite!
Mark
Re: PRI Free Float Tube for DPMS
I just built a DPMS type .308 on Iron Ridge upper and lower. I used a PRI rifle length free float tube with a 20 inch barrel. I love the PRI. I couldnt be happier with it. Pricey, but extremely well engineered and built.
I just built a DPMS type .308 on Iron Ridge upper and lower. I used a PRI rifle length free float tube with a 20 inch barrel. I love the PRI. I couldnt be happier with it. Pricey, but extremely well engineered and built.
Re: PRI Free Float Tube for DPMS
Never was fond of how they looked, that is, until I handled the triangular model at SHOT. Nice handguard.
www.apexcncmachine.com
Never was fond of how they looked, that is, until I handled the triangular model at SHOT. Nice handguard.
www.apexcncmachine.com
