Gunsmithing Productive Sunday.
- Thread starter 300sniper
- Start date
The bearing in that thing definitely won't work. Should have gone with a Dewalt
Dewalt chucks are more concentric than mulwaukee. For precision riflea Dewalt is the preferred tool.
You should definitely rethink what you're doing here man. That carpet is gonna suck those shavings right up, you'll never go barefoot again. Do it over a hard surface.
Be sure and post a range report!!!
I have adjusted them for minimal endplay and have verified acceptable TIR at the chuck. It's good to go!
And you used liberal doses of WD-40 for cutting fluid I hope ?..........It's the best there is, don'tcha know ?
Plenty of WD or PB Blaster and run that bitch on low, should be gtg!
I find running it dry and fast on the hammer setting works best. The chips come out blue hot so I know the heat is not going into the barrel or tool.
Dry, on hammer setting ? Jeez, why didn't I think of that ! Brilliant !
You should watch using the hammer setting. When the hammer hits the anvil your likely to get some run out. Just sayin...
I like using drills with cheap levels in them so you can stay really true to the contour, bore don't really matter the only thing that matters is your fundamentals.
Run it backwards with a yawing motion every so often too. That'll make extraction easier. The Army's machine guns are like that, so you know it's good to go.
Tapered Gamut Bearings in that spindle? lol....
That bottle of Jack sitting behind the KMW will help with concentricity!!!
I can't believe nobody else has noticed it, lmao!
