PSS stock and badger DBM

[ROLEXrifleman]

To do this install, do the factory pillars need to be removed? Or just inlet the trigger gaurd like the HS DBM?

TIA

 

[Cixelsyd]

Re: PSS stock and badger DBM

You'll need to remove some of the aluminum block that the HS stock is built around. Need to make the distance match the pillars that Badger sends. I did an LTR stock a while back.


CHRIS

 

[dmg308]

Re: PSS stock and badger DBM

You can go either way I just did one with a Surgeon bottom today.I like punching it out and installing the supplied pillars.I dont like the way the HS doesn't go all the way to the bottom of the reciever.Just make sure you clearence out all the necessary material so the BM sits flush on the pillars.Then you will have the correct feed height.