Night Vision Question on Badger EFR

[JoshMarines]

I have the pictures below EFR bottom piece looking to buy the pictured below upper rail. My question is will the square pegs on the upper rail work with my bottom piece? Anyone with the same EFR please comment or show picts thanks in advance

 

[NighthawkCG]

A bit confused on your question, but the top piece fits into the bottom piece and screws keep it together. As long as they are both badger pieces that are unmodified, they should fit together nicely. The lower is recessed to fit those square sections.

 

[JoshMarines]

A bit confused on your question, but the top piece fits into the bottom piece and screws keep it together. As long as they are both badger pieces that are unmodified, they should fit together nicely. The lower is recessed to fit those square sections.

The top rail I have now uses pins to hold in place as well as screws. I just wasn’t sure if thh square pieces on that top rail will fit in those cut outs

 

[NighthawkCG]

Maybe they changed designs?? I bought one last year and don’t think there were pins. I can check tomorrow. If I recall correctly, the squares on the top pice fit into a little channel in the bottom and keep the top from sliding front and back. No pins that I recall. On cell phone but looking closer at bottom pic, yours may not have that channel. Will try to pull mine apart tomorrow and get an answer if someone else doesn’t give you a better one first.

 

[JoshMarines]

Awesome thank you

 

[RTH1800]

I had several around the time the M40 A5 came out. None had pins. They indexed on and screwed down. Call Marty at Badger and see what he says.

 

[NighthawkCG]

Just checked again - no pins on mine. The square one the top picks indexes to a square cut out on the bottom. Other than that, it is 6 screws. I second what rth1800 said - call Badger and see.