Razor Gen II 5 inches high at 100 yards and bottomed out

[devildawg2531]

This may be a super simple question but I haven't had this before. My MPA BA 6.5CM has a Spuhr mount for my Vortex Razor Gen II. The MPA and the Spuhr mount have some elevation built in causing the impacts to be 5 inches high at 100 yards with the scope bottomed out. Is this corrected by just resetting the zero stop the 13 clicks or so needed? Thanks and sorry if this is a dumb question.. but want to confirm before messing it up.

 

[Feesh]

Yup - follow the zero instructions in the manual. A copy can be found at the bottom of the page here.

Razor HD Gen II 4.5-27x56 FFP

Please Select Reticle | 34mm Tube

vortexoptics.com

 

[Steel head]

Yes, You should be able to adjust the zero stop.
You’d need 45+ moa of rail/mount to bottom out a Razor.

 

[sam4886]

If it already has a zero stop set, definitely just reset it.

 

[Rob01]

Old video but shows how to zero. You leave the outer knobs locked on 0 and take the cap off and loosen the allens and then use the inner screw to adjust. There will be no clicks to feel as it's a clickless zero so you can get a perfect zero.