Redding bushing change part location help

[dave300]

My 7-300 build is near completion and I cannot find the correct part or part number for changing my Redding competition 300 WM bullet seating bushing out to the correct 7mm bullet seating bushing. I have the correct neck sizing bushings to reduce the neck down, just needing to find the 7mm bullet seating bushing.
I may just consider a entire Redding 7mm comp bullet seating die depending on cost differences. Thanks!

 

[Mad_Charlie]

Did you mean seating STEM,,,???

 

[dave300]

Mad Charlie, pretty sure that is all that I need (seating stem) in order to seat the 7MM bullets using the 300 WM Comp die? If so Id prefer to use the afermarket stem designed for the VLD's, I will be load developing using the berger 7MM 180 Hybrids and the 180 VLD's. I presume this stem will be one in the same.
Sorry for all the questions, but Im using my smart phone and the search is not locating the stem, as most of the sites are taking me to the mobile version PIA. Thanks in advance for your input.

Did you mean seating STEM,,,???

 

[Mad_Charlie]

Call Redding.

 

[lawman29]

bullet alignment bore & seating stem are almost same diameter: Working With Your Competition Seating Die | Redding Reloading Equipment: reloading equipment for rifles, handguns, pistols, revolvers and SAECO bullet casting equipment