Redding S Type .308 Neck Die for .260 Remington?

[bm11]

I believe I've asked this before, but it's been years and I can't find the answer. If you were to swap out the bushing and decapping rod, is there any reason why a .308 bushing neck die couldn't be used for a .260? I know that the neck/shoulder junction is higher on the .260 relative to the case head, but most dies don't size all the way to the neck/shoulder junction anyhow.

Thoughts? I can't find the .260 die in stock, and I don't want to FL size all of this brass this time around.

Thanks,

-Bob

 

[bm11]

24 hour thread bump!