Gunsmithing Relief cut out in stock for 700 X-Mark trigger?

[300WSM]

Anyone know if there is a special relief cut out in stocks which come from the factory (specifically the PSS stocks) with the new X-Mark trigger? Apparently it's a little bigger?

 

[300WSM]

Re: Relief cut out in stock for 700 X-Mark trigger?

anyone?

 

[wirehand]

Re: Relief cut out in stock for 700 X-Mark trigger?

When I replaced a stock on a x-mark equiped rifle there was a little material that needed to be removed.
The saftey would not clear.

Does this help ?

 

[Busby.]

Re: Relief cut out in stock for 700 X-Mark trigger?

Yes the x mark trigger is wider. The stocks have to be relieved for that trigger. If you have an older stock with the x mark remington will mill it out for a fee.

 

[300WSM]

Re: Relief cut out in stock for 700 X-Mark trigger?

Thanks guys.

 

[eddybo]

Re: Relief cut out in stock for 700 X-Mark trigger?

I just did one of these last week, not a problem with a mill. It would probably go pretty fast with a dremel as well.