Remington 700 ADL - Action Screw Torque?

[Norcal707]

Manual for my new 700 ADL with cheap plastic stock does not list a torque specification for re-tightening the stock to action screws. Anyone know what the recommended spec is for the main front/rear screws and the smaller trigger guard screw? Also, is there a recommended tightening pattern, IE, rear then front, etc.? Will be changing the stock & bottom metal out down the road to accept detachable mags but until then need the specs for this POS stock.

Image below shows cheap stock for reference.

 

[Boltfluter]

I have have had good luck with 45"lbs front and 25"lbs on the rear.


Paul

www.boltfluting.com

 

[MACHTECH]

Til' they start squeaking ?. Just kidding.... I always torque the front to 50 in/lb and the rear to 35 in/lb. Oh, and I start with the front first.