Rifle Scopes Ring height for AR flat top?

[Nutro]

I might have screwed up on my dads build as the mount I just received is listed as 1.6" centerline and I'm fearing that will be too high.

I looked through the sticky up above but didn't see much for gas sticks.

 

[Drifter™]

Should be fine. ~1.5" (+ or - 0.1") centerline scope height above the rail usually works for most people.

 

[2_many_dogs]

Depends on the objective bell diameter. Divide that by 2 and add a bit for scope cap.

 

[Nutro]

Well hell I might fucked up. The scope is a Steiner 4-16x50 and mount is a Bobro 34mm.

 

[Drifter™]

Well hell I might fucked up. The scope is a Steiner 4-16x50 and mount is a Bobro 34mm.

You should be fine with that combo.

 

[bhoges]

Get this and don't look back. I wasted time and money with rings and bases. Here is my baby.
AADMOUNT 20 MOA PRECISION AR SCOPE MOUNT

 

[Nutro]

Get this and don't look back. I wasted time and money with rings and bases. Here is my baby.
AADMOUNT 20 MOA PRECISION AR SCOPE MOUNT

Yeah I've been looking at those and Alamo and even the Spuhr. Nice looking rifle.

 

[Nutro]

Does anyone know if I can use a Spuhr mount with 44MOA built in? This will be used with either a Steiner 4-16x50 Military G2 or NF 3-15 F1

Or would I be better served by a Spuhr mount with 0MOA?