I finally finished my first form 1 suppressor. Titanium tube, end cap and welded on front sight. K's are made of 6061-T6. Let me know what you think, I am pretty happy how it turned out as it shoots like a laser with the extended sight radius.
Suppressors Ruger MK II Form 1 Project
- Thread starter fockell
- Start date
Re: Ruger MK II Form 1 Project
what is that nub on the bottom of the tube under the front sight?
Is that a screw?
Pics of the baffles?
Closeup of the weld? I am a sucker for good welds on titanium.
what is that nub on the bottom of the tube under the front sight?
Is that a screw?
Pics of the baffles?
Closeup of the weld? I am a sucker for good welds on titanium.
Re: Ruger MK II Form 1 Project
Yea
Those are small screws on both ends, wasn't my original plan but it was the only way I could consistently get not ends to orientate correctly. I intend on detenting it one of these days.
No welds visible, the cap was pocketed and beveled for the front blade then welded in and machined back flat.
Ks are typical, total of 8 gives me about 2.2" of blast baffle area. I turned the diameter of the barrel down to .500" and cut it back to about 3" oal.
Yea
Those are small screws on both ends, wasn't my original plan but it was the only way I could consistently get not ends to orientate correctly. I intend on detenting it one of these days.
No welds visible, the cap was pocketed and beveled for the front blade then welded in and machined back flat.
Ks are typical, total of 8 gives me about 2.2" of blast baffle area. I turned the diameter of the barrel down to .500" and cut it back to about 3" oal.
