I was wondering if anyone knew of a controlled feed bolt head conversion for a savage 10 308?
Gunsmithing savage 10 controlled feed?
- Thread starter 916dude!
- Start date
Re: savage 10 controlled feed?
The Savage short mags use a control round feed.
BUT:
To convert a standard setup would require milling an extra slot in the receiver for the ejector as it is held in place by the trigger mounting pin.
And change the bolt head - here is where I see a problem - to my knowledge, they don't make a CRF bolt head for 308. If you knew a machinist - maybe he could adapt or modify.
The Savage short mags use a control round feed.
BUT:
To convert a standard setup would require milling an extra slot in the receiver for the ejector as it is held in place by the trigger mounting pin.
And change the bolt head - here is where I see a problem - to my knowledge, they don't make a CRF bolt head for 308. If you knew a machinist - maybe he could adapt or modify.
Re: savage 10 controlled feed?
That answers my question! Thanks deadeye
That answers my question! Thanks deadeye
