Rifle Scopes Scope ring height for Bergara

[LongRange65]

Ordered a new Bergara BMP along with a Vortex razor 4.5x27x56 scope. I also ordered Seekins
20ma scope base. I know I should wait to order rings so I can measure the height. But I was hoping
to order everything and have it show up so I can put this together. Anyone have the set up or
have any suggestions on what scope ring height I should go with? Looking at Seekins/Vortex
rings either .092 or 1"

 

[Nathan11B]

I ran mediums and had plenty of room mind you that was 50mm objective. Think mediums would work for your situation.

 

[LongRange65]

Thats the .920's correct?

 

[Nathan11B]

Yes, use the .920 or 1inch 34 mm Vortex rings. If you wanna go fancy get a sphur mount but I’m not familiar at all with them.

 

[bschneiderheinze]

I run nightforce meds with my Razor and M24 barrel and there perfect

 

[LongRange65]

Thanks for the replies. I appreciate it.

 

[SwiftScope]

I know it's not the same setup but here is my LRP with the Badger "Highs" at 1.125 with a Nikon 4-16x50. It's a bit taller than most but it works. Hope this helps with a visual.