Does anyone know the hex key size of the rear takedown capture screw? I assume they normally come with the key, but mine didn't. It's a tiny little thing! Found one in the toolbox that is maybe one size too big but I have no idea what size it is.
- Thread starter springer01
- Start date
Re: Seekins lower rear take down pin detent..question
Not sure what size without trying, but for the record mine didn't come with a hex key either.
Make sure you cut the spring's length down before trying to install the plunger and spring.
Not sure what size without trying, but for the record mine didn't come with a hex key either.
Make sure you cut the spring's length down before trying to install the plunger and spring.
Re: Seekins lower rear take down pin detent..question
Ok thanks! Had to trim the front spring too stuck out about 1/8". I might just take it to hardware store and try some out tomorrow.
Ok thanks! Had to trim the front spring too stuck out about 1/8". I might just take it to hardware store and try some out tomorrow.
Re: Seekins lower rear take down pin detent..question
Found one! Just in case anyone needs to know its a .050 hex key.
Found one! Just in case anyone needs to know its a .050 hex key.
Similar threads
