Normally I use a K&M with some extra bits and pieces I've accumulated, but for various reasons I ended up with a Forster outside neck turner (ONT) head and pilot for .30 cal, with the intention of chucking the shaft for the head in a drill press and using the collet base clamped to the dp table. Special project, 'nuf said.
Compared to what I'm used to (K&M), the adjustments on the Forster seem *extremely* coarse. Anybody have any experience and/or tips on getting one of these suckers dialed in without wasting a lot of cases in the process?
Compared to what I'm used to (K&M), the adjustments on the Forster seem *extremely* coarse. Anybody have any experience and/or tips on getting one of these suckers dialed in without wasting a lot of cases in the process?