SOLD pending funds
FS: Atlas V8 (BT10-NC V8 https://www.accu-shot.com/catalog_n...l-manufacturer/67-bt10-nc-v8-atlas-bipod.html) with Atlas BT19 spigot mount (https://www.accu-shot.com/catalog_n...bt19-atlas-accuracy-international-spigot.html). Currently the two are separate but are designed to work together.
Bipod has minimal use, i quickly switched to a CAL and its been sitting round ever since. It has no screws unless you buy it with the spigot mount which is ugly (altho mechanically 100%). I used loctite on the spigot mount threads and snugged it down with a wrench, so its a little marred on the knob. However I found once I did this it didn't move at all. AND...one of the screws you attach the bipod to is borderline stripped, too much loctite when I installed that one i guess.. It'll go in fine though, just have to be careful taking it out.
$180 for the bipod alone shipped CONUS.
$40 for the spigot mount alone shipped CONUS.
$210 for both.
PP FF only plz.
FS: Atlas V8 (BT10-NC V8 https://www.accu-shot.com/catalog_n...l-manufacturer/67-bt10-nc-v8-atlas-bipod.html) with Atlas BT19 spigot mount (https://www.accu-shot.com/catalog_n...bt19-atlas-accuracy-international-spigot.html). Currently the two are separate but are designed to work together.
Bipod has minimal use, i quickly switched to a CAL and its been sitting round ever since. It has no screws unless you buy it with the spigot mount which is ugly (altho mechanically 100%). I used loctite on the spigot mount threads and snugged it down with a wrench, so its a little marred on the knob. However I found once I did this it didn't move at all. AND...one of the screws you attach the bipod to is borderline stripped, too much loctite when I installed that one i guess.. It'll go in fine though, just have to be careful taking it out.
$180 for the bipod alone shipped CONUS.
$40 for the spigot mount alone shipped CONUS.
$210 for both.
PP FF only plz.
Last edited:
