Rifle Scopes Steiner M5Xi Zero Stop Question

[whatsupdoc]

After sighting in the scope I loosened the elevation cap set screws and zeroed out the cap and tightened the set screws .

So now it goes past Zero by 2 clicks, Is this normal?

Thanks

 

[Afkirby]

Not sure if it’s normal for this particular scope but many zero stops will actually stop a few tenths of a mil below zero

 

[JMGlasgow]

Normal

 

[lennyo3034]

Normal, designed that way.

 

[whatsupdoc]

Thanks just making sure!

 

[msat10]

Had the same issue, talked to Steiner, made that way.

 

[JR869]

Hmmm, I though Steiner did 3/10th not 2 for the over travel. You might want to verify that with them.

 

[lennyo3034]

Hmmm, I though Steiner did 3/10th not 2 for the over travel. You might want to verify that with them.

The T5xi is .3. My M5xi is .2 and my old Military was .2.

 

[JR869]

The T5xi is .3. My M5xi is .2 and my old Military was .2.

Got it, that is where I got the .3 from, it is the T scope

 

[whatsupdoc]

Why dont they put this stuff in the manual?