Hey everyone, new guy here. Currently working on my first rifle build and need to modify the stock. The stock is a fairly expensive stock and has been glassed and bedded(i dont want to mess it up). The width of the front of the stock is a litle wide and uncomfortable for me. Is there someone that can mill this down or can i sand it down myself with a pnuematic sander? Will this affecxt the integrity of the stock or the accuracy. I would need to take off about 1/8 to 3/16 on each side.Synthetic/fiberglass webbed HS stock. Any suggestions would be appreciated.
Stock mod question
- Thread starter P & Y
- Start date
Re: Stock mod question
Welcome to Snipers Hide.
There's quite a few "how to" posts in the archives that talk about stock mods. Use this for your search, you should be able to find what your looking for:
SH Search Engine
Welcome to Snipers Hide.
There's quite a few "how to" posts in the archives that talk about stock mods. Use this for your search, you should be able to find what your looking for:
SH Search Engine
