i have a mcm htg stock with williams bottom metal, 700 bdl barreled action and a rock m40 barrel sitting in the garage that i need to get all put together soon. lately i've been thinking about using a detach mag system on this rifle... could i use a detach mag system on this stock already inlet for the williams bottom metal? or do i need another stock?
stupid question about mcm htg stock
- Thread starter brutus1776
- Start date
Re: stupid question about mcm htg stock
Have seen a few of the USMC M40A1 turn-in stocks with the Badger M5 DBM added and it looks like it has worked well! Member "Matchking" has a picture of an old smear with it installed in the "Precision Rifles....Show em" thread....
here.... Precision Rifles......Show em.... about 1/2 way down the last page.... May want to drop him a PM for pointers..
Have seen a few of the USMC M40A1 turn-in stocks with the Badger M5 DBM added and it looks like it has worked well! Member "Matchking" has a picture of an old smear with it installed in the "Precision Rifles....Show em" thread....
here.... Precision Rifles......Show em.... about 1/2 way down the last page.... May want to drop him a PM for pointers..
Re: stupid question about mcm htg stock
brutus1776, if you decide to go the DBM route & the Williams bottom metal you have is the 2 piece M40A1 type bottom metal, I'll buy it from you... pm sent!
brutus1776, if you decide to go the DBM route & the Williams bottom metal you have is the 2 piece M40A1 type bottom metal, I'll buy it from you... pm sent!
Re: stupid question about mcm htg stock
ggarrett1911... yeah, i have the m40a1 type metal.. i'll let you know.
ggarrett1911... yeah, i have the m40a1 type metal.. i'll let you know.
Re: stupid question about mcm htg stock
No problem doing it. You'll just need it reinletted for the DBM. Costs like $70 to do at GA Precision. I have a HTG that was using Williams bottom metal and got the DBM done a few years ago and it works great. Also had it done to an M40A1 return stock for my .243.
No problem doing it. You'll just need it reinletted for the DBM. Costs like $70 to do at GA Precision. I have a HTG that was using Williams bottom metal and got the DBM done a few years ago and it works great. Also had it done to an M40A1 return stock for my .243.
