Hey. I hate that I have already sent the rifle off without getting to try my Griffin PSR can I had BSD Fabrication jail break for me to us with the CA762SSAL/RE flash hider. He used one of his warlock mounts which uses an 1.375 x 24 thread and I am sure if you wanted him he does the warden conversions and could use it. Only thing we did was put a tiny pin on the underside of the flash hider so it locks into the grove that a new style SureFire would use. It’s barely noticeable. Once again I wish I had a picture before it left to get a little repair work done.
I just wanted to share he did a real nice job was easy to deal with and did a good job of keeping me updated and did not mind me asking questions. I just wanted to share in case someone was looking for away to get a suppressor for their older style mount. I will give a complete update when the rifle comes home and I get to go shoot it. But here’s a few pictures.
It will need to be Cerakoted once I get it tested. Or I’ll just buy a mirage cover and won’t care because it will be covered up.
I just wanted to share he did a real nice job was easy to deal with and did a good job of keeping me updated and did not mind me asking questions. I just wanted to share in case someone was looking for away to get a suppressor for their older style mount. I will give a complete update when the rifle comes home and I get to go shoot it. But here’s a few pictures.
It will need to be Cerakoted once I get it tested. Or I’ll just buy a mirage cover and won’t care because it will be covered up.
Last edited:
…nice work forsure…
