Unlike my standard Remington actions (none 3lug), I can't use my ejector tool. Aside doing it the normal route, grabbing a piece of brass and placing it into bolt face and then punching the ejector pin. Does anyone know of an easier way of doing this on these 3lug bolts?
- Thread starter jeffr
- Start date
I just checked headspace on mine. Perhaps this isn't the best method but it worked flawlessly. Wrapped the bolt in a towel and placed in a vice vertically. Roll pin punch from the bottom side of the bolt body(roll pin hole is smaller on the bottom of the bolt body. The punch retained the spring and ejector. Remove punch and catch the spring and ejector.
