- Mar 15, 2018
- 1,381
- 5,434
I’ve learned a lot being a member of this Forum. One thing I’ve learned is that there are certain subjects that elicit the same reaction as casually mentioning at a Shoah Foundation Convention that, “that Hitler guy wasn’t all bad”. I think neck turning might fall into that category. Assume the following:
- You buy new Lapua brass in .338 LM
- You acurately measure 10 cases (taking 4 measurements on each case) using a Mitutoyo digital ball micrometer
- Which shows that the variation in neck thickness is a maximum of .001” between your sample of 10