I am turning quite a few necks prepping brass for my 7mm-300WSM. I have a decent Sinclair neck turning tool that I am using by hand. It works fine but I would like to cut down on the time it takes if I can. I remember reading a while back about some accessories that were being used to neck turn with a cordless drill. I have not had any luck finding these old topics with search and any help with what tools may help would be greatly appreciated.
Tools for neck turning
- Thread starter WunderDog
- Start date
Re: Tools for neck turning
"I remember reading a while back about some accessories that were being used to neck turn with a cordless drill."
I've long chucked cases directly in a Dewalt 1/2" battery drill motor for turning but I can't get magnum sized cases in it. For magnums I use a Lee case trimmer shell holder and stud chucked in the drill. Run at slow speed with a hand held turner, this is quite accurate and very fast.
"I remember reading a while back about some accessories that were being used to neck turn with a cordless drill."
I've long chucked cases directly in a Dewalt 1/2" battery drill motor for turning but I can't get magnum sized cases in it. For magnums I use a Lee case trimmer shell holder and stud chucked in the drill. Run at slow speed with a hand held turner, this is quite accurate and very fast.
Re: Tools for neck turning
Sinclair intl makes a case holder/driver that works very well.It cost more than the Lee driver,but works about the same way. Lightman
Sinclair intl makes a case holder/driver that works very well.It cost more than the Lee driver,but works about the same way. Lightman
Re: Tools for neck turning
I 2nd Ken Markels equipment (K&M tool)! I have nothing but great things to say about his stuff. One hell of a good guy too!
Terry
I 2nd Ken Markels equipment (K&M tool)! I have nothing but great things to say about his stuff. One hell of a good guy too!
Terry
