I think I read on here somewhere that the action in an HS Precision PSS stock should be torqued to 61 in. lbs. I can't seem to find that thread again. Is that correct or a little high?
Thanks, JH
Thanks, JH
- Thread starter stater61
- Start date
Re: Torque range for Rem. 700
No. Factory specs for factory stock and bottom metal is between 45 and 50 inch pounds.
Some get away with 65 inch pounds but with factory bottom metal you are in danger of splitting it at the action screw hole.
No. Factory specs for factory stock and bottom metal is between 45 and 50 inch pounds.
Some get away with 65 inch pounds but with factory bottom metal you are in danger of splitting it at the action screw hole.
Re: Torque range for Rem. 700
45 to 65 inch pounds is standard, depending on the beding.
45 to 65 inch pounds is standard, depending on the beding.
Re: Torque range for Rem. 700
Thanks guys I appreciate it.
Thanks guys I appreciate it.
