I thought I'd pass along this info;
The other day I had a informative conversation with Mr. Chris Bezzina (main engineer at Savage Arms) who played a key part in the development of the AccuStock.
I wanted to get detailed information on torque specs for the 10 LE weapons series. There is a sequence for reassembling in the manuals but for ultimate accuracy wanted by advanced shooters the recommended sequence is;
Proper Adjustment of The AccuStock
there is a specific technique for assembling the action into the AccuStock,
and it needs to be strictly adhered to as follows:
1. Ensure that the recoil lug “wedge”
screw is backed out to the point where
the wedge has sufficient vertical movement to allow the recoil lug to seat
against the bottom of the aluminum rail.
2. With the action inserted into the
stock, justify the action toward the rear
of the stock to allow the recoil lug on
the action to be seated against the boss
on the aluminum rail.
3. Tighten the forward most screw to
10 in.-lbs. to seat the action against the
aluminum rail boss, then back out one-
half turn.
4. Tighten the middle action screw to 10
in.-lbs.
5. Tighten the rear action screw to 10
in.-lbs.
6. Tighten the forward action screw to
10 in.-lbs
Repeat steps four through six and
increase torque value in increments up
to a final torque value of 40 to 45 in.-lbs.
note: It is extremely important to
tighten per the instructions above
because when you are tightening the
action down into the AccuStock you are
spreading the aluminum side rails and
evenly moving the action down onto
the base of the rail, ensuring positive
engagement.
—Chris Bezzina, Savage Arms
The other day I had a informative conversation with Mr. Chris Bezzina (main engineer at Savage Arms) who played a key part in the development of the AccuStock.
I wanted to get detailed information on torque specs for the 10 LE weapons series. There is a sequence for reassembling in the manuals but for ultimate accuracy wanted by advanced shooters the recommended sequence is;
Proper Adjustment of The AccuStock
there is a specific technique for assembling the action into the AccuStock,
and it needs to be strictly adhered to as follows:
1. Ensure that the recoil lug “wedge”
screw is backed out to the point where
the wedge has sufficient vertical movement to allow the recoil lug to seat
against the bottom of the aluminum rail.
2. With the action inserted into the
stock, justify the action toward the rear
of the stock to allow the recoil lug on
the action to be seated against the boss
on the aluminum rail.
3. Tighten the forward most screw to
10 in.-lbs. to seat the action against the
aluminum rail boss, then back out one-
half turn.
4. Tighten the middle action screw to 10
in.-lbs.
5. Tighten the rear action screw to 10
in.-lbs.
6. Tighten the forward action screw to
10 in.-lbs
Repeat steps four through six and
increase torque value in increments up
to a final torque value of 40 to 45 in.-lbs.
note: It is extremely important to
tighten per the instructions above
because when you are tightening the
action down into the AccuStock you are
spreading the aluminum side rails and
evenly moving the action down onto
the base of the rail, ensuring positive
engagement.
—Chris Bezzina, Savage Arms