Trimmer for .375 CT

[mdslammer]

Hello,

What are you guys using to trim your .375 Cheytac brass?

I have a RCBS Trimmer Pro electric and it works great for my .338 Lapua.

However, they do not make a shell holder plate large enough to accommodate the size of the .375 case for this trimmer.

Any help would be great.

Thanks

 

[Jeremy338]

Rcbs makes a 50 trimmer. It will accept the Cheytac case head.

 

[CoryT]

I use the Wilson 50 cal with their holder for the .375, works very well.

 

[Eric_F]

Do the 375 and 408 CT have the same shoulder? If so, the WFT Big Boy should work with this bushing: https://www.littlecrowgunworks.com/store1/408-Cheytac-p118340668

 

[Geno C.]

I modified a bushing and use the Lyman powder trimmer. Thing works perfect

 

[Jeremy338]

Rcbs is a one and done setup. Under 200$ if I remember correctly

 

[Hoser]

The Wilson trimmer is perfect.

 

[GIXXER2000]

I use the Girard power trimmer. It very fast and repeatable.

 

[mdslammer]

Hey guys, thanks very much for the tips.
Will check into a few of them.

 

[mdslammer]

I modified a bushing and use the Lyman powder trimmer. Thing works perfect

Hey Geno,
Thanks for posting. So there is NOT a bushing made for a .375 Cheytac case? What
did you have to do to "modify" it?
Thanks.
Mark

 

[Geno C.]

Not sure if there is or not. I’m pretty sure there isn’t for the Snipetac that I run though.

I modified it by running my reamer into one and opening the center holE