Victor company shooting way low

blues2o

Private
Minuteman
Feb 15, 2017
22
3
6
Just got a victor company stock for my 10/22 target installed stock and rear spike per there instructions. Went to go re zero poi shifted down about 10 inches at 50 yards ran out of elevation in my cheap bushnell. Does this sound out of the norm?
 

WAsquirrelsniper

Private
Belligerents
Oct 18, 2012
181
54
34
34
Washington
Did the old stock have a pressure pad at the tip? Like on an older magpul stock maybe? I know when I switched mine it shifted quite a bit lower but didnt measure by how much.
 

blues2o

Private
Minuteman
Feb 15, 2017
22
3
6
It did have a pad but I sanded it out that’s when I found the action rocking in the stock so I ordered the victor company.
 

blues2o

Private
Minuteman
Feb 15, 2017
22
3
6
I re zeroed in the wood stock and it held zero just didn’t group well at all. Then I put it in the new stock it was shooting so low I ran out of elevation trying to zero it. It did seem to be grouping better.
 

blues2o

Private
Minuteman
Feb 15, 2017
22
3
6
I planned on upgrading the scope. I’m thinking a bushnell forge 2.5x15. Just didn’t plan on upgrading this soon but if I do order a new scope should I plan on getting a 20 Moa base?
 

blues2o

Private
Minuteman
Feb 15, 2017
22
3
6
I checked the v block they are tight and barrel is floating I even put a washer under the action screw to make sure it wasn’t bottoming out
 

Js9088

Private
Minuteman
Feb 15, 2019
13
6
6
I had the same issue with the victor stock/spike set-up on my volquartsen summit. I was running a pst gen2 and only had 10moa up from my 50 yard zero. It shot great though so I left it alone and bought Burris xtr rings with the inserts to get about 45 moa back. I like the setup and it shoots lights out but I think the spike puts a weird torque on the receiver.
 

blues2o

Private
Minuteman
Feb 15, 2017
22
3
6
I ordered a 20 Moa base yesterday and a bushnell forge. Specs say it has 80moa of elevation so with the base hopefully I’ll have 60 Moa of up travel if that’s not enough to shoot to 100yards this thing is going down the road.
 

Js9088

Private
Minuteman
Feb 15, 2019
13
6
6
I ordered a 20 Moa base yesterday and a bushnell forge. Specs say it has 80moa of elevation so with the base hopefully I’ll have 60 Moa of up travel if that’s not enough to shoot to 100yards this thing is going down the road.
Good luck. My volquartsen has 20moa integral I believe.
 

Nodak

Sergeant of the Hide
Belligerents
Minuteman
Mar 27, 2019
117
58
34
I've been messing with 10/22's for a long time and I'd bet money that if you swapped out the barrel block for a "Gunsmither" block you'd be gtg.