Will the Magpul Bad Lever still work with a Vltor MUR upper receiver? I notice that the MUR has a cutout for the standard bolt release and was wondering if it would accomadate the Bad Lever.
- Thread starter jakhamr81
- Start date
Re: Vltor MUR upper / Bad Lever??
The monolithic rails or just the receivers?
The monolithic rails or just the receivers?
Re: Vltor MUR upper / Bad Lever??
It fits on mine. It does rest against the upper (VERY tight fit), but seems to function normally.
It fits on mine. It does rest against the upper (VERY tight fit), but seems to function normally.
Re: Vltor MUR upper / Bad Lever??
Mine does fine.... never had a snag.
Mine does fine.... never had a snag.
Re: Vltor MUR upper / Bad Lever??
I am inquiring about the forged upper receivers that Noveske is using on their builds.
I am inquiring about the forged upper receivers that Noveske is using on their builds.
Re: Vltor MUR upper / Bad Lever??
I'm not sure what Noveske is using, but what I have is a VLTOR MUR with the assist. It is forged and I don't think they make a special MUR for Noveske. You could call Sheri at Noveske and ask her. She's very helpful. They have great customer service.
Sheri
Noveske Rifleworks LLC
Ph:541-479-6117
Fx:541-479-2555
I'm not sure what Noveske is using, but what I have is a VLTOR MUR with the assist. It is forged and I don't think they make a special MUR for Noveske. You could call Sheri at Noveske and ask her. She's very helpful. They have great customer service.
Sheri
Noveske Rifleworks LLC
Ph:541-479-6117
Fx:541-479-2555
