What factory action for a 6.5 PRC project ?
- Thread starter Rec1er
- Start date
Magnum bolt face with 300 WSM mags. Talk with a smith who does a lot in the long range/PRS game for most current precision rifle stuff is what I suggest.
You are better off buying a Mack Bros Evo for less than 600 than any factory action, IMO. You can use a factory Tikka or something else nice, but it will be about that and are limited on aftermarket parts.
You are better off buying a Mack Bros Evo for less than 600 than any factory action, IMO. You can use a factory Tikka or something else nice, but it will be about that and are limited on aftermarket parts.
Maybe , maybe not, but check this out . Stainless Savage https://grabagun.com/firearms/rifle...el-2-rounds-3-9x40mm-vortex-crossfire-ii.html6.5 PRC with 24" Bbl.
That's a junk ass rifle (the savage), it'll always be half ass after a pile of upgrades.
Buy an Evo action
Buy an Evo action
Factory, Tikka all the way. scour the pawn shops for a used T3 or T3X.
Depends on where you want to end up I guess but if you can find a Savage action like a model 10 that is factory blueprinted it should treat you well. It is not an Impact or Kelbly but it is serviceable and you can install the barrel yourself with a few tools.
Tikka will be your best bet for a factory action, will allow you to seat the bullets as far out as you like if you handload. There’s a good aftermarket for the tikka now and you can buy 6.5 prc prefit barrels from many different vendors, with or without a barrel nut. If you are okay with going away from factory the Evo would be a good option.
Question for y'all - if you went with any long action magnum, your magazine and reciever would have extra length. Will that extra length cause "sloppy" feeding, or does it work fine? Seems like it would work OK.
Last edited:
I am new to the gun building world. Can you explain why it wouldn’t have to be a magnum with the .532 bolt face?
Thanks,
Josh
I'll get on that Tikka train. I bought an Ultralite a month ago and haven't touched anything since... it is just right.
It DOES need a .532 bolt face if you're not going to change the way it came from the "factory". Shooter71 is saying that a .473 bolt face can be enlarged to .532 by a machinist/gunsmith, as he did above.
Last edited:
