a fired case to fit in the chamber one way but turn it 180* and it won't fit? Did a chamber cast and all looks to be good. Action is a mauser, rebarreled to 22/6mm.
Gunsmithing What would cause,
- Thread starter LSandBinc
- Start date
Re: What would cause,
I can't see that on the chamber cast or the cases don't look bulged.
I can't see that on the chamber cast or the cases don't look bulged.
Re: What would cause,
Check the runout on the chamber cast.
Check the runout on the chamber cast.
Re: What would cause,
Its .005 on the middle of the neck. Most all cases run the same with a few at .009
Its .005 on the middle of the neck. Most all cases run the same with a few at .009
Re: What would cause,
I had this on an AR barrel In my case the chamber was cut "out of round". Worst part was no good way to fix in my situation, if it was a bolt gun I might have had the chamber cut off and recut
I had this on an AR barrel In my case the chamber was cut "out of round". Worst part was no good way to fix in my situation, if it was a bolt gun I might have had the chamber cut off and recut
