Doing a load workup for my .308 gasser...
LC 07 brass, Hornady 150 FMJBT, and SW Match rifle powder.
SW load data says 2.75 OAL, but I think they're using Jagemann brass.
Hornady says 2.700 OAL which would put the case mouth in the cannelure.
Should I use the Hornady OAL and crimp in the cannelure? Or go with the longer length and crimp wherever?
I'm starting at the bottom and working up in .4 gr increments. Plan to keep an eye on things as I proceed.
Any suggestions/advice appreciated.
Mike
LC 07 brass, Hornady 150 FMJBT, and SW Match rifle powder.
SW load data says 2.75 OAL, but I think they're using Jagemann brass.
Hornady says 2.700 OAL which would put the case mouth in the cannelure.
Should I use the Hornady OAL and crimp in the cannelure? Or go with the longer length and crimp wherever?
I'm starting at the bottom and working up in .4 gr increments. Plan to keep an eye on things as I proceed.
Any suggestions/advice appreciated.
Mike