• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Winchester SRP + H4350 + Lapua Small Rifle Brass = OK?

Joeg26er

Sergeant of the Hide
Full Member
Minuteman
Jul 26, 2018
374
111
Winchester SRP + H4350 + Lapua Small Rifle Primer Brass = OK?

Also have Varget to work with

Would like to know if this is a dead nuts reliable recipe before plunking down for some Lapua small rifle primer brass at about $1 per casing

Thanks also for any load recipes for Sig Cross 18" or Tikka Tac A1 20" PVA barrel (have one of each rifle) will use with Dead Air Nomad LT
 
I have heard reports of hang fires but I think that was with non Winchester small rifle primers?

I have Hornady ELDX 143g and Barnes Matchburner 140g
Appreciate any load development people might want to share for Sig Cross or Tikka Tac A1
 
yes- edited - 6.5 CreedMoor: Winchester SRP + H4350 + Lapua Small Rifle Brass = OK?
There was an article not that long ago on large vs small in 6.5 Creed. There were some stating it was a bad idea to use small primer brass in anything but hot weather. The comparisons they did ended up showing no advantage by going small primer. I'm sure some will disagree but that was coming from people a hell of a lot smarter and with better equipment than I will ever own.
 
There was an article not that long ago on large vs small in 6.5 Creed. There were some stating it was a bad idea to use small primer brass in anything but hot weather. The comparisons they did ended up showing no advantage by going small primer. I'm sure some will disagree but that was coming from people a hell of a lot smarter and with better equipment than I will ever own.
But no disadvantage either?
 
Disadvantage was inconsistent ignition. If I remember correctly, the large primers produced better accuracy and lower sd
Which SRPs were they using?

ETA: Found this article, results slightly favored Wolf LRP over CCI 450 on SDs in Starline brass with a larger flash hole, but there were multiple charge weights of H4350 where the SRP had better SD than the LRP. Results look to be pretty inconclusive to me, but also Lapua has a smaller flash hole in their SRP brass (1.5mm vs 2.0mm), so it'd be interesting to compare Lapua LRP vs SRP brass instead of Starline.



And another article assessing the differences:
 
Last edited:
answer found in an Outdoor Wire article - Lapua says:

"“We’ve found that for some applications, like tactical semi-automatic rifles, a Large Rifle Primer is required to ensure function and performance. Lapua created this product to meet that requirement.”"in inclement weather conditions. The Large Rifle cases improve ignition consistency where extreme temperature swings are prevalent."