Suppressors Wrench for TBAC Flash Hider

[mdmp5]

What size wrench takes off the TB flag hider? My adjustable’s jaws are too thick, and my ¾ open end is too small. I calipered the flats at .770 or so

 

[BurnOut]

What size wrench takes off the TB flag hider? My adjustable’s jaws are too thick, and my ¾ open end is too small. I calipered the flats at .770 or so

Try a 19 mm.

 

[mdmp5]

I was gonna do that, but the calipers measure roughly 19.5mm. Does the 19 work for you?

 

[MrSmith]

Put a layer or two or three of masking tape on each flat and use whatever size fits snug. Mine takes one layer on each flat and a 1" wrench

Thank you,
MrSmith

 

[BurnOut]

I was gonna do that, but the calipers measure roughly 19.5mm. Does the 19 work for you?

I've never tried it on a TBAC flash hider... I was just going off of general wrenching experience.

 

[pell1203]

Surprised TBACRAY or Zak Smith haven't chimed in. Must be on vacation... they are both from TBAC and always extremely helpful!

 

[mdmp5]

Actually, I apologize for not updating this thread. Talked to Ray today, and he said to use an adjustable wrench because the size is not standard. I went to HD and got a small Husky adjustable wrench and it worked.

 

[Strykervet]

Hey, been there, done that, and if you use a bit of tape on there to prevent marring, the wrench size that "almost fits" will fit well, and work like a charm while not marking up the brake in the process.

 

[mdmp5]

The closest would be a 20mm. The adjustable worked well for me so I have no need to try anything else. My first choice would definitely have been a proper size open end for sure if there was one