WTB Winchester Internal Magazine/ 1 Piece Floor Plate For FN PBR Swap

[WRXican]

I found a used FN PBR at Cabelas last month and I couldn't resist. It's a .308 and its got a 24" threaded barrel with the detachable box magazine setup. I am trying to swap the DBM for the Model 70 1 piece floor plate. Does any one have the parts that they may have swapped out for their own build? I am aware that I would need a stock thats inlet for that setup. Thank you.

 

[USNavy06]

I just bought a pbr myself last week. Midwest gun works has some steel 1 piece floor plates. They are a bit expensive but they are nice. They also have some nice McMillan stocks for the model 70/Fn rifles.

 

[WRXican]

Yeah I saw that too. All the stocks they sell are set up for the 1 piece floor plate too so that's partly what's got me motivated to make the swap. I'm hoping someone has the parts I'm looking for but if not, I'll go the Midwest route. Did you do the swap?

 

[USNavy06]

Yeah I bought a McMillan A3g for $199 and I bought their steel floor plate for $175

 

[WRXican]

Is that all you need for the swap? I thought there was more to it than just the floor plate.

 

[USNavy06]

Is that all you need for the swap? I thought there was more to it than just the floor plate.

Get the box mag and 308 follower.