Has anyone done load development for the Warner Tool Co. 30 CAL 198 Grain projectiles in their 300 WM ? and if so will you please share your data and long range accuracy results !
Thanks !
Thanks !
WTC 198 Grain / 300 WM
- Thread starter wapiti16b
- Start date
I have found that 190 smk and 200.20x shoot better than anything I could hope for. No reason other than curiosity to spend time and money on different bullets. They might be the next best thing but will have to find a way into the main stream. Perhaps you will lead the way with spectacular results...
Honestly I was just hoping to gather information without spending $$$ to see if the cost would be justified . I may give them a try and if I do I will post results regardless of spectactularity ! .
In the meantime if anyone has gone down this rabbit hole PLEASE post your findings !
In the meantime if anyone has gone down this rabbit hole PLEASE post your findings !
You might go look over on LongRangeOnly.com and LongRangeHunting.com. I know that there are a lot of ELR guys that use Warner Tool products and I see them discussed a lot. I can’t offer any personal experience but I know those 2 forums can provide you with some info. Good luck!
FWIW- I’m itching for one of their die sets.
Sent from my iPhone using Tapatalk
FWIW- I’m itching for one of their die sets.
Sent from my iPhone using Tapatalk
Also, contact the folks at Warner Tool - they will help you out with starting load recommendations. Very nice folks and helpful. If they don't, Josh at PVA certainly can (he is the bullet designer). Josh is on here as username bohem
Similar threads
