Been using this machine for 10 years and thousands of rounds, never had a problem I could not figure out...
Have not loaded much .308 but started again and went well for 50 rounds and then stuck a case. Yep there was some range brass involved. I know,I know.
Anyway have tried 2 other sizing dies run against the plate and still getting occasional oversized case.
Is it possible I have damaged machine? Bent the platform? I did tighten platform bolts.
And have weeded out all oddball headstamps.
any ideas ?
Thanks
Have not loaded much .308 but started again and went well for 50 rounds and then stuck a case. Yep there was some range brass involved. I know,I know.
Anyway have tried 2 other sizing dies run against the plate and still getting occasional oversized case.
Is it possible I have damaged machine? Bent the platform? I did tighten platform bolts.
And have weeded out all oddball headstamps.
any ideas ?
Thanks