Recent content by Hijeffrey95

Looking for Nightforce ATACR 4-20x50 F1 Mil, Schmidt Bender 3-12x50, or Premier Reticles

I DMed you

Got the rifle back from MHS yesterday, they did a annual inspection along with cutting the throat. Closing the action with and without a round now feels about the same but resistance still feels more compared to other actions Ive tried out. What I did notice, when the safety is in the middle...

For legacy AI rifles (AW, AICS, AE, etc.) Used, light marks, comes with roll pin $800 shipped

Looking for Spuhr SA 4601 6 MIL mount for AI Dovetail

Would a Spuhr 44.4 MOA cant mount with a S&B 3-12x50 PMII be zeroable at 100m? My AI comes with the dovetail

Where can I find the bottom sling stud part for an AI? Mine currently has a much larger sling stud and I want the smaller ones so I can mount a harris bipod on it

My rifle did come with a KAC NVG mount that Ill probably sell whenever I get it back

The Interesting thing is my issue also occurred with fired cases too. They said they will check headspacing too as part of their inspection.

Sent the rifle to MHS, they told me it had a really short free bore, is this normal on AI barrels? Its a factory barrel

yeah I can push it down flat, I dont think the ejector is the issue

yeah I havent really taken it out of the safe for a while now, playing around with snapcaps again, it had the most resistance actually chambering a round, when the casehead is interacting with the extractor, after chambering the snapcap and reopening the action then closing it again with the...

I have not

I know this is a old post but just wanted to update it. ejector looks fine, chamber looks free of anything. I cleaned the bolt face a bit along with the ejector and extractor. I used some snap caps and noticed the rims were getting beat up pretty bad. Perhaps its something wrong with the...

I will try this out and inspect the chamber in the next few days